Printing From A Desired Starting Point - Canon iPF655 - imagePROGRAF Color Inkjet Printer User Manual

Printing From a Desired Starting Point

When printing inside boundaries or in other situations when you want to specify a particular position to start
printing from, set Width Detection to Off in the printer menu for the type of paper used.
Set Width Detection to Off
1.
On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Paper tab (
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Paper Menu is displayed.
3.
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4.
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5.
Press ▲ or ▼ to select Width Detection, and then press the OK button.
6.
Press ▲ or ▼ to select Off, and then press the OK button.
Load paper in the desired position to start printing from
Follow these instructions to load paper at the desired starting position for printing when Width Detection
is Off.
1.
If you did not send a print job in advance, a menu for selection of the type of paper is displayed.
Press ▲ or ▼ to select the type of paper, and then press the OK button.
Note
•
If a print job was received before paper was advanced, the media type and size specied by the job
are shown on the Display Screen.
Thus, this screen is not displayed. Go to step 2.
2.
Width Detection OFF. OK to continue? is now shown on the Display Screen. Press ▲ or ▼ to
select Leave OFF, and then press the OK button.
3.
After a menu for selection of the paper size is displayed, press ▲ or ▼ to select the paper
size, and then press the OK button.
Handling rolls
).
Handling Paper 115