ProForm CROSSTRAINER Owner's Manual page 6

7. _Insertthe Iowei. end oFthe LeEArm (15} into the lee
: side of the h_ment Ann (74). Make sure that the
bracket on the end of the LeftArm is positioned as
! shown in the inset drawing. If the bracket is"_ot
i positioned as shown,, the LeftArm will not f_nction
proper_y.
Tap-a 3/4" PlasticCap (57) onto one oF t_ endsoF
a 3/4' x 4" J_e (54). Align the hole in the end oF
the Left _ (15} with the holesin the Moment Ann
: (74). Insert the AxJeinto the Momenb_-m and the
LeftArm. Tea a 3/4" PlasticCaa onto the Axle.
•Note: An exlTa 3/4' Plastic Cap (57) hc_ibee'-h _: -
included with the hardware Pock. If you accldentol.
_ly damage one of the Plastic Caps during assem-
bly, use the extra Plastic Cap. Othenvlse, the exh'a
•Plastic Cap may be discarded.
:,_.toch theRight A rn'l(i6) in thesamemanner.
.
Wrap the Weight Cable (52) under th_ 3 1/2=!
Pu ey (5) on the lower end of the Upright (9). Make
.'surethat the Cable is belween _ Cable Tr,_p(67)
_nd the Pulley. Tighten the 3/8 I_ock Nut (6)
altachlng the Pulleyto the Upright.Make_ure Ihat
the Cable Trao is in _a _'7 "
_'ck_k" ,_osltlon.
I.ay the Weight Cable (52) over a 3 1/2' Pulley(5).
_ach a Cable Tra_ (67) and thehlley to the left
_ide oEtheuprighi (9) with a 3/8 x 1 3/4 Bolt
(40) and 3/8" F._k N_ (6). Make sure that the
Cable Trap is in the "12 o'clock" Position.
Wrap theWelght Cable (52)a_bUh'da-2_' PUl]_(4). :
_ttach the Pulleyto the Left'Arm (15) wit\hla 3/8" x
1 3/4" Bolt{40) and 3/8" N_4ockNut 16|.
9. Wrap the Weight Cable (52) around a _3/4"
Pulle); (13). Attach the Pulley tothe indicated b?acket
on the up ght(g) 3/8-.x 13/4" lt 4_oj.
and 318" Nvln_.k N,_ I._,1_:'_" _ "
8
40
67
_, I l'="i /='1 .