Advertisement
Available languages
Available languages
Dryer Dimensions
Mobile
home
- Additional
installation
requirements
This dryer is suitable
for mobile
home installations.
The installation
must conform
to the
Manufactured
Home Construction
and Safety Standard,
Title 24 CFR, Part 3280
(formerly
the
Federal Standard
for Mobile
Home Construction
and Safety, Title 24, HUD
Part 280) or
Standard
CAN/CSA-Z240
MH.
Mobile
home
installations
require:
•
Metal exhaust system hardware,
which
is available
for purchase from your dealer.
•
Mobile
Home Installation
Kit Part Number
346764.
See "Tools
and Parts" section for
information
on ordering.
•
Special provisions
must be made in mobile
homes to introduce
outside
air into the dryer.
The opening
(such as a nearby window)
should
be at [east twice as large as the dryer
exhaust
opening.
*Most installations
require a minimum
5" (12.7 cm) clearance
behind
the dryer for the
exhaust
vent with
elbow.
See "Venting
Requirements."
Installation
spacing
for recessed
area or closet
installation
The following
spacing dimensions
are recommended
for this dryer. This dryer has been tested
for spacing
of 0" (0 cm) clearance
on the sides and rear. Recommended
spacing
should
be
considered
for the following
reasons:
•
Additional
spacing should
be considered
for ease of installation
and servicing.
Additional
clearances
might be required
for wall,
door and floor
moldings.
Additional
spacing should
be considered
on all sides of the dryer to reduce
noise transfer.
For closet installation,
with
a door, minimum
ventilation
openings
in the top and bottom
of the door are required.
I.ouvered
doors with
equivalent
ventilation
openings
are
acceptable.
Companion appliance spacing should also be considered.
Additional
spacing is required
if you exhaust
out the rear of the dryer to either the right or
left side.
1" _
[_- 29"-_ m_-i,, -_1,,,_
27V4"H5" '_-
(2.5cm) (73.7 c m) (2.5cm} (2.5 cm)(69.2cm} (12.7 c m)
A
B
48in.2._
(316 c m 2 )
24 _,2,
(156cm_)
-
C
==_
3 I1.
(7.6cm)
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground
prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow
these instructions can result in death,
fire, or electrical
shock.
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
*Required
spacing
•
120 Volt, 60 Hz., AC only, 15- or 20-amp
fused electrical
supply
is required.
A time-delay
fuse or circuit
breaker
is recommended.
It is also recommended
that a separate circuit
6
Advertisement
