Advertisement
Available languages
Available languages
5o
6o
Install screws in the top hinge holes in the door. Do not tighten
screws.
I.eave
approximately
'/4" (5 mm) of screw exposed.
A. Insta//
these screws
first.
Hang door by placing
screw
heads into top slotted
holes of hinges and slide door down.
Align
bottom
screw
holes in hinge and door. Install two bottom
screws. Tighten
all hinge
screws.
7.
Close door to engage door strike.
1.
Check that all parts are now installed.
If there is an extra part, go back through
the steps to
see which
step was skipped.
2.
Check that you have all of your tools.
3.
Dispose
of/recycle
all packaging
materials.
4.
Check the dryer's final location.
Be sure the vent is not crushed
or kinked.
5.
Check that the dryer is level. See "l.evel
Dryer."
6o
7.
8,
9.
10.
11.
12.
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground
prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow
these instructions can result in death,
fire, or electrical
shock.
Plug into a grounded
3 prong outlet.
Turn on powen
Remove any protective
film or tape remaining
on the dryer.
NOTE: Glass door models
have a protective
film on the window
that should
be removed.
Read "Dryer
Use."
Wipe
the dryer drum interior
thoroughly
with
a damp
cloth to remove
any dust.
If you live in a hard water area, use of a water softener
is recommended
to control
the
buildup
of scale through
the water system in the dryer. Over time,
the buildup
of lime
scale may clog different
parts of the water system, which
will reduce
product
performance.
Excessive scale buildup
may lead to the need for certain
part replacement
or repair.
Test dryer operation
by selecting
a Timed
Dry heated cycle and starting the dryer. For this
test, do not select the Air Fluff modifier.
If the dryer will not start,
check the following:
•
Controls
are set in a running
or "On"
position.
•
Start button
has been pushed firmly.
•
Dryer is plugged
into a grounded
3 prong outlet.
•
Electrical
supply
is connected.
•
Household
fuse is intact and tight, or circuit
breaker has not tripped.
•
Dryer door is closed.
When
the dryer has been running
for 5 minutes,
open the dryer door and feel for heat. If
you feel heat, cancel
cycle and close door. If you do not feel heat, turn off the dryer and
check that the gas supply
line shutoff valve is open.
•
If the gas supply
line shutoff valve is closed,
open it, then repeat the 5-minute
test as
outlined
above.
•
If the gas supply
line shutoff
valve is open,
contact
a qualified
technician.
Advertisement
