Advertisement
Available languages
Available languages
Dryer
displaying
code
message
"PF"
(power failure),
check the following:
Was the drying
cycle interrupted
by a power failure?
Depending
on the length of the power
outage,
you may be able to resume the cycle by
simply
pressing START/PAUSE;
otherwise,
press POWER/CANCEl.
and then start a new
drying
cycle.
"F" Variable
(F1, F2, F20, etc.) service codes:
Call for service.
Clothes
are not drying
satisfactorily,
drying
times
are too long, or load
is too hot
Is the lint screen clogged with lint?
I.int screen should
be cleaned
before each load.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow
these instructions can result in death
or fire.
Is the exhaust vent or outside exhaust hood clogged with
lint, restricting
air movement?
Run the dryer for 5-1 0 minutes.
Hold your hand under the outside
exhaust
hood to check
air movement.
If you do not fee[ air movement,
clean exhaust
system of lint or replace
exhaust
vent with
heavy metal or flexible
metal vent. See the Installation
Instructions.
Are fabric
softener
sheets blocking the grille?
Use only one fabric
softener
sheet, and use it only once.
Is the exhaust vent the correct length?
Check that the exhaust
vent is not too long or has too many turns.
I.ong venting
will
increase
drying
times. See the Installation
Instructions.
Is the exhaust vent diameter
the correct size?
Use 4" (1 0.2 cm) diameter
vent material.
Explosion
Hazard
Keep
flammable
materials
and vapors,
such
as
gasoline,
away
from
dryer.
Place
dryer
at least 18 inches
(46 cm) above
the floor
for a garage
installation.
Failure
to do so can result
in death,
explosion,
or fire.
Is the dryer located in a room with
temperature
below 45°F (7°C)?
Proper operation
of dryer cycles
requires
temperatures
above 45°F (7°C).
Is the dryer located in a closet?
Closet doors must have ventilation
openings
at the top and bottom
of the door. The rear of
the dryer requires
5" (12.7 cm) of airspace,
and the sides and front of the dryer require
a
minimum
of 1" (2.5 cm). See the Installation
Instructions.
Has the Air Fluff modifier
been selected?
Select the right temperature
for the types of garments
being dried.
See "Modifiers."
Is the load too large and heavy to dry quickly?
Separate the load to tumble
freely.
2 4
Advertisement
