Spa Blank Filler Plates; Spa Cable-Management Brackets - Cisco CRS-1 - Carrier Routing System Router Hardware Installation Manual

Chapter 6 Installing and Removing a SPA
Table 6-1
Command
show hw-module fpd
show version

SPA Blank Filler Plates

SPA blank filler plates are available to fill an unused SPA subslot.
When a SPA subslot is not in use, a SPA blank filler plate must be installed in the empty subslot to allow
the router or switch to conform to electromagnetic interference (EMI) emissions requirements and to
allow proper airflow across the SPAs. If you plan to install a new SPA in a subslot that is not in use, you
must first remove the SPA blank filler plate.

SPA Cable-Management Brackets

SPAs are shipped with an accessory kit that includes cable-management brackets.
To install or remove cable-management brackets on a SPA, see
steps:
Screw the two pull assemblies into both sides of the SPA.
Step 1
Insert the cable-management bracket into the slot.
Step 2
Step 3 To remove the cable-management bracket, press the button on the bracket and pull it out.
Blank filler plugs are provided if no cable-management brackets are installed.
Note
OL-17439-01
show Commands to Display SPA Information (continued)
Type of Information Provided
FPD version information of SPAs in the system.
Cisco IOS XR software version, names and sources of configuration
files, and boot images.
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide

SPA Blank Filler Plates

Figure 6-6 and perform the following
6-9