Cisco CRS-1 - Carrier Routing System Router Hardware Installation Manual page 97

Chapter 7 Troubleshooting the Installation
The Cisco Systems original packaging is to be used for the shipment of all SPAs and cable-management
Caution
brackets. Failure to properly use Cisco Systems packaging can result in damage or loss of product.
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Note These instructions assume that the SPA and cable-management brackets have been removed from the
router according to the recommended procedures specified in this guide.
To pack a SPA and the cable-management brackets for shipment, perform the following steps:
Open the Thermoform container and place the SPA and each of the cable-management brackets into the
Step 1
appropriate cavities.
Always handle the SPA by the carrier edges and handle; never touch the SPA components or connector
Caution
pins.
Close the Thermoform container. Be sure to lock the snaps securely.
Step 2
Check that the Thermoform container is fully closed. Apply tape or a label closure over the opening to
Step 3
ensure the container stays closed during shipping.
Place the Thermoform container into the carton.
Step 4
Close the carton.
Step 5
Apply tape over the carton flap to ensure the carton stays closed during shipping.
Step 6
OL-17439-01
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
Packing a SPA for Shipment
7-5