Shared Port Adapters - Cisco CRS-1 - Carrier Routing System Router Hardware Installation Manual

Preface
Table 1
Revision
OL-7113-03
OL-7113-02
OL-7113-01
Organization
This document contains the following chapters:
Section
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
OL-17439-01
Changes to This Document
Date Change Summary
October 2006 Information was added to

Shared Port Adapters,"

•
•
•
•
Port number information for these SPAs was updated in
Chapter 2, "Overview: Cisco CRS-1 SPA Interface Processor."
Optics and compatibility information for these SPAs was updated
in Chapter 1, "SIP and SPA Product Overview."
April 2006 Information about the 8-Port OC-12c/STM-4 Multirate POS SPA
was added to
Adapters."
"Packing a SIP for Shipment"
Installation,"
July 2005 Initial release of the document.
Title
SIP and SPA Product Overview
Overview: Cisco CRS-1 SPA
Interface Processor
Overview: Cisco CRS-1 Shared Port
Adapters
Preparing to Install a SIP or a SPA
Installing and Removing a SIP
Installing and Removing a SPA
Troubleshooting the Installation
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
Chapter 3, "Overview: Cisco CRS-1
about the following SPAs:
2-Port and 4-Port OC-48c/STM-16 POS SPA
5-Port Gigabit Ethernet SPA
10-Port Gigabit Ethernet SPA
1-Port 10-Gigabit Ethernet SPA
Chapter 3, "Overview: Cisco CRS-1 Shared Port
in
was added.
Description
Provides a brief introduction to the SPA interface
processors (SIPs) and shared port adapters (SPAs).
Provides a SIP and SPA compatibility summary.
For each supported SIP, it provides a summary of
SIP characteristics and a SIP overview.
For each supported SPA, provides a summary of
SPA characteristics and a SPA overview.
Describes the required tools, equipment, and
safety guidelines for installing SIPs and SPAs.
Describes the procedures for installing and
removing a SIP on the Cisco CRS-1 router.
Describes the procedures for installing and
removing a SPA on the Cisco CRS-1 router. It also
describes how to verify the SIP and SPA
installation.
Provides information for troubleshooting the
installation of SIPs and SPAs. It also describes
helpful debug commands and error messages.
Chapter 7, "Troubleshooting the
ix