Memory Module Removal; Locating The Memory Slot Cover And Screw - NEC POWERMATE eco Service And Reference Manual

Memory Module Removal

Remove the SO-DIMM memory module as follows.
Close all applications, shut down the operating system, turn off system power, and unplug
1.
the AC power adapter and power cord from the power source and the back of the system.
2. Turn off and disconnect all peripherals.
system AC power adapter before removing the back cover. Power is removed only when the AC
power adapter is unplugged from its power source.
Carefully position the system on a clean, flat, soft surface, with the LCD panel facing down.
3.
surface is clean, flat, smooth and free of any objects before positioning the system face down.
Remove the back cover (see "Rear Cover Removal" earlier in this chapter).
4.
proceed:
To prevent injury by electric shock, make sure the AC power adapter is unplugged from its
power source. Power is removed only when the AC power adapter is unplugged from its
power source.
To avoid a burn, wait at least 30 minutes after powering off the system and before you touch
the system board shield and memory slot cover. During system operation, the system board
shield and memory slot cover become hot.
5. Remove the screw securing the memory slot cover and remove the cover.
3-6 Disassembly and Reassembly
To prevent electric shock, turn off system power and unplug the
To prevent damage to your LCD panel screen, be sure your work
To prevent personal injury, follow these precautions before you

Locating the Memory Slot Cover and Screw

A – System Board Shield
B – Screw
C – Memory Slot Cover