Powermate Eco Application And Driver Cd; Powermate Eco Product Recovery Cd; Performing Full Disk Restore - NEC POWERMATE eco Service And Reference Manual

PowerMate eco Application and Driver CD

The PowerMate eco Application and Driver CD provides drivers, utilities, an Internet browser,
and a variety of software applications for use with the system. Use the CD to install the
applications or to reinstall any applications that might have become corrupted.
Use these procedures to launch the Application and Driver CD.
1. Insert the PowerMate eco Application and Driver CD into the CD-ROM drive. The CD auto
runs. The Application and Driver CD dialog box appears.
In the Application and Driver CD dialog box, click the selection tab of your choice and
2.
click the desired driver, utility, or application.
3. Click Install and f
Click
4. Exit
5. Remove the CD from the CD-ROM drive when the installation is complete.

PowerMate eco Product Recovery CD

The PowerMate eco Product Recovery CD contains the Product Recovery utility that allows you
to restore the system to its initial installation state.
You should only use the Product Recovery CD as a last resort. Check the problem checklist in
Chapter 7 for information about solving problems before using the Product Recovery CD. The
Product Recovery CD provides options that either remove or replace existing files, a process that
can result in data loss.
Carefully review the following Product Recovery CD information before proceeding with a
system restore.
applications installed on the system. NEC Solutions (America), Inc. suggests that you contact
Technical Support Services for assistance in restoring the hard drive. See Chapter 8 for
information on obtaining NEC Solutions (America), Inc. support.
Use the Restore System program if you want to restore the hard drive to its factory-installed
state. Restore System allows you to restore the system in one of two ways.
Full Disk Drive — This option completely rebuilds the hard drive, destroying all existing
data in the process.
Partition Only — The Partition Only option lets you preserve the existing hard drive
partition structure and format only the primary partition without affecting the extended
partition(s).

Performing Full Disk Restore

If the preinstalled software becomes unusable and you cannot boot from the hard drive, use the
Product Recovery CD to restore the system to its initial shipping configuration. The Full Disk
restore option erases the hard drive completely before reinstalling the files.
replaces them with the original factory-installed files. Only use the Full Disk Drive restore option if
the preinstalled software is unusable.
ollow the screen prompts to install the selection.
to close the Application and Driver CD dialog box.
Choose the restore option carefully to prevent losing data and
The Full Disk Drive restore option deletes all files on the hard drive and
Setup and Configuration 2-17