Extreme Networks 200 Series Installation And User Manual page 51

Table 14: Common Commands (continued)
Command
config sys-recovery-level [none | critical | all]
config time <date> <time>
config timezone <gmt_offset> {autodst | noautodst}
config vlan <name> ipaddress <ip_address>
{<mask>}
create account [admin | user] <username>
{encrypted} {<password>}
create vlan <name>
delete account <username>
delete vlan <name>
disable bootp vlan [<name> | all]
disable cli-config-logging
disable clipaging
disable idletimeouts
disable ports <portlist>
Summit 200 Series Switch Installation and User Guide
Description
Configures a recovery option for instances
where an exception occurs in
ExtremeWare. Specify one of the
following:
• none—Recovery without system
reboot.
• critical—ExtremeWare logs an
error to the syslog, and reboots the
system after critical exceptions.
• all—ExtremeWare logs an error to the
syslog, and reboots the system after
any exception.
The default setting is none.
Configures the system date and time. The
format is as follows:
mm/dd/yyyy hh:mm:ss
The time uses a 24-hour clock format. You
cannot set the year past 2036.
Configures the time zone information to
the configured offset from GMT time. The
format of gmt_offset is +/- minutes from
GMT time. Specify:
• autodst—Enables automatic Daylight
Savings Time change.
• noautodst—Disables automatic
Daylight Savings Time change.
The default setting is autodst.
Configures an IP address and subnet
mask for a VLAN.
Creates a user account. This command is
available to admin-level users and to users
with RADIUS command authorization. The
username is between 1 and 32 characters,
the password is between 0 and 16
characters.
Creates a VLAN.
Deletes a user account.
Deletes a VLAN.
Disables BOOTP for one or more VLANs.
Disables logging of CLI commands to the
Syslog.
Disables pausing of the screen display
when a show command output reaches
the end of the page.
Disables the timer that disconnects all
sessions. Once disabled, console sessions
remain open until the switch is rebooted or
you logoff. Telnet sessions remain open
until you close the Telnet client.
Disables a port on the switch.
Common Commands
49