Accessing Extremeware Vista - Extreme Networks 200 Series Installation And User Manual

Using ExtremeWare Vista on the Summit 200
• Check for newer versions of stored pages. Every visit to the page should be selected as a cache
setting.
If you are using Netscape Navigator, configure the cache option to check for changes "Every Time"
you request a page.
If you are using Microsoft Internet Explorer, configure the Temporary Internet Files setting to check
for newer versions of stored pages by selecting "Every visit to the page."
• On older-browsers you might need to specify that images be auto-loaded.
• Use a high-resolution monitor to maximize the amount of information displayed in the content
frame. The recommended resolution is 1024 x 768 pixels. You can also use 800 x 600 pixels.
• Turn off one or more of the browser toolbars to maximize the viewing space of the ExtremeWare
Vista content screen.
• If you will be using ExtremeWare Vista to send an email to the Extreme Networks Technical Support
department, configure the email settings in your browser.
• Configure the browser to use the following recommended fonts:
— Proportional font—Times New Roman
— Fixed-width font—Courier New

Accessing ExtremeWare Vista

After an IP address is assigned to the VLAN, you can access the default home page of the switch.
1 Enter the following command in your browser:
http://<ipaddress>
The home page for the Summit 200 opens as shown in Figure 41.
248 Summit 200 Series Switch Installation and User Guide