Pim Sparse Mode (Pim-Sm) Overview; Configuring Pim-Sm - Extreme Networks 200 Series Installation And User Manual

Summit 200 series
Table of Contents

Advertisement

IP Multicast Routing and IGMP Snooping

PIM Sparse Mode (PIM-SM) Overview

Protocol independent Multicast-Sparse Mode (PIM-SM) routes multicast packets to multicast groups.
The sparse mode protocol is designed for installations where the multicast groups are scattered over a
large area such as a wide area network (WAN). PIM-SM is a router-to-router protocol, so all routers and
switches must upgrade to the same PIM-SM version. Summit 200 switches use PIM-SM version 2 to
forward IP packets that are destined to the IP addresses in the Class D Range to multiple networks
using the Multicast Routing information setup.
PIM-SM is an explicit join and prune protocol that is a mixture of the shared tree and shortest path tree
(SPT) models. The routers must explicitly join the group(s) in which they are interested in becoming a
member, which is beneficial for large networks that have group members who are sparsely distributed.
PIM-SM is not dependant on a specific unicast routing protocol. The Summit 200 supports IGMP, which
allows network hosts to report the multicast group membership to the switch.
Using PIM-SM, the source router sends a join message to a known rendezvous point (RP). The RP is a
central multicast router that is responsible for receiving and distributing multicast packets. RPs are
elected by a bootstrap router (BSR). The job of the BSR is to broadcast bootstrap messages, disseminate
RP information, and to elect the RP. You may only configure the Summit 200 switches as an RP in static
mode, which means that all switches in your network must be configured with the same RP address for
the same group (range). Summit 200 switches are not eligible to be BSRs.
When a source router has a multicast packet to distribute, it encapsulates the packet in a unicast
message and sends it to the RP. The RP decapsulates the multicast packet and distributes it among all
member routers.
When a router determines that the multicast rate has exceeded a configured threshold, that router can
send an explicit join to the originating router. Once this occurs, the receiving router gets the multicast
directly from the sending router, and bypasses the RP.
On stacked configurations, PIM-SM is supported on the stack master (slot 1).

Configuring PIM-SM

You can configure two active and 254 passive interfaces on a Summit 200 for PIM-SM. By default the
interface is configured as active. To enable the interface as passive, specify the
enable the interface as active, omit the
PIM-SM on an IP interface.
configure pim {add | delete} {vlan} <vlan name> sparse {passive}
For example, to add a VLAN named lobby, as an active interface, you would enter:
configure pim add vlan lobby sparse
To configure an RP and its associated groups statically:
configure pim crp static <rp address> [none | <access profile>] {<priority
[0-254]>}
The
contains a list of multicast group accesses served by the RP.
access profile
230
keyword. The following command enables or disables
passive
keyword; to
passive
Summit 200 Series Switch Installation and User Guide

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Summit 200-24Summit 200-48

Table of Contents