Extreme Networks 200 Series Installation And User Manual page 275

Configuring the Summit 200 using ExtremeWare Vista
Figure 66: VLAN Administration (1 of 2)
Renaming a VLAN
The following section allows you to rename a VLAN. When renaming a VLAN, be sure to following the
naming guidelines described in "VLAN Names" on page 102. This area of the window is also shown in
Figure 66.
Configuring a VLAN
This section of the VLAN window allows you to change VLAN parameters. Use the pull-down menu to
choose an existing VLAN name and click Get to populate the remaining fields.
Use the following fields to make changes to a VLAN:
IP Address—Either changes the IP address or unconfigures the IP address. The Unconfigure button
resets the IP address of the VLAN; the Submit Changes button allows you to assign a different IP
address to the VLAN.
Netmask—Specifies a subnet mask in dotted-quad notation (e.g. 255.255.255.0).
802.1Q Tag—Adds an 802.1Q tag to the VLAN. Acceptable values range from 1 to 4094.
Spanning Tree Domain—Assigns the VLAN to a STPD.
QoS Profile—Assigns a QoS profile to the VLAN.
The next box adds ports to the VLAN. You can either add the port as tagged or untagged. If you click
Tagged, the port is added as a tag-based port. If you click Untagged, the port is added as an untagged
port.
Summit 200 Series Switch Installation and User Guide 273