Table of Contents
Advertisement
Figure 31: Attaching the 19-inch Helper Bracket to the System Rack
4 Clean the surfaces that will meet on the rack-mount brackets and the rack uprights. Apply
antioxidant treatment to the surfaces.
5 Lift the back of the empty BlackDiamond 12804 chassis onto the helper bracket.
6 Slowly guide the chassis into the system rack until the mounting brackets are flush against the rack
uprights.
7 Attach the chassis to the system rack using eight rack mounting screws and washers. (Screws are not
provided.) Be sure that the screws are secure. Refer to
NOTE
Figure 32
shows a standard rack mount. For mid-mount installation, use the same mounting locations shown in
the figure, but insert the screws through the designated slot locations of the mid-mount brackets.
BlackDiamond 12800 Series Switches Hardware Installation Guide
Rack-Mounting the BlackDiamond 12804 Chassis
EX_086A
Figure 32
for the screw locations.
63
Advertisement
Table of Contents
