Extreme Networks 12800 Series Hardware Installation Manual page 87

Figure 49: Securing the BlackDiamond 12804 AC Power Cord Retainer
Install and secure the channel bracket to
the switch by tightening both captive screws
Captive screw
5 Starting from the left, lay the first four power cords into the channel (see
6 Lay the last two power cords on top of the bottom four cords (see
Figure 50: Routing the Power Cords in the Channel
From the left, lay first four
power cords into channel bracket
Lay last two power cords
onto others
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always available
when you need to handle ESD-sensitive components.
BlackDiamond 12800 Series Switches Hardware Installation Guide
Using the BlackDiamond12804 AC Power Cord Retainer Channel
Captive screw
EX_139
Figure 50).
Figure 50).
87