Table of Contents
Advertisement
Extreme Networks Power Supply Units for BlackDiamond Switches
Specifications
The 700/1200 W AC PSU functions from 90 V to 264 V and 47 Hz to 63 Hz AC Input. Each PSU
provides 700 W to the system if the AC input is in the 110 V low-line output power range and 1200 W
to the system if the AC input is in the 220 V high-line output power range.
A greater number of PSUs are needed to support the load if the low-line power range is used to power
the switch. The software determines the maximum available power required for the switch and enables
the modules accordingly.
CAUTION
The 700/1200 W AC PSU does not have a switch for turning the unit on and off. Remove the plug from the
electrical outlet to disconnect power to the 700/1200 W AC PSU. Make sure that this connection is easily
accessible.
Make sure that the 700/1200 W AC PSU circuit is not overloaded. Use proper over-current protection, such as a
circuit-breaker, to prevent over-current conditions.
Extreme Networks 325 W DC Power Supply
Figure 17
shows the Extreme Networks
Model 65022. This power supply is compatible with the BlackDiamond 12802 switch. Up to three 325 W
DC PSUs can be installed in the BlackDiamond 12802 switch.
NOTE
A minimum of two Extreme Networks 325 W DC PSUs are required to run a BlackDiamond 12802 switch.
Figure 17: Extreme Networks 325 W DC PSU
325W DC PSU
NOTE
For centralized DC power connection, this product is intended to be installed only in a restricted access location (for
example, a dedicated equipment room, equipment closet, or central office) in accordance with Articles 110-16,
110-17, and 110-18 of the National Electric Code, ANSI/NFPA 70.
34
®
325 W DC UL-listed accessory power supply unit (PSU),
.
Torino DC PSU_04A
BlackDiamond 12800 Series Switches Hardware Installation Guide
Advertisement
Table of Contents
