Operate Visionpro 8000 Touchscreen; Set Time; Manual Override Of Fan Schedule; Set Temperature Overrides - Honeywell VisionPRO 8000 Owner's Manual

VisionPRO TM 8000 Touchscreen Programmable Thermostat
Manual Override of Fan Schedule (Table 8)
Auto--fan is automatically following the Fan schedule
(choices are Auto, On or Circulate).
On--overrides Fan schedule. Fan is continuously On.
Circ--overrides Fan schedule. Fan circulates randomly for
approximately 35% of time until the Auto position is selected.
Operate VisionPRO TM8000 Touchscreen
Set Time
1. Press Clock.
2. Use arrows to set current time.
Table 8. Manual Override of Fan Schedule Operation.
Screen
Fan Message
Schedule Call Under
Fan Override for Energize Fan
Setting Setting Action Terminal Setting
Auto On Fan G On
Auto Circ None None Circ
Auto Circ Fan G Circ
On Auto a -- -- --
On Circ None None Circ
On Circ Fan G Circ
Circ Auto a -- -- --
Circ On Fan G On
aAuto Override resumes the Fan Program in each schedule
period (Wake, Leave, Return and Sleep)
TUE
I1--1i_ t hM_
I1--1_ _1 --I
M19958
3. Press Done key.
IMPORTANT
The current day of the week should already be set
correctly. If not, see Installer Setup to set the day.
Set Temperature Overrides
The thermostat has three temperature override options: Hold
Temperature Until, Permanent Hold and Vacation Hold.
HOLD TEMPERATURE UNTIL (TEMPORARY HOLD)
Holds temperature temporarily until the next scheduled period
time or until the time the user sets.
1,
Press Up or Down arrow next to the temperature you
want to adjust. "Hold Temperature Until" time appears
on the screen. The Hold Temperature Until time defaults
to the start time of the next scheduled period.
NOTE:
The Time Up and Down arrows are shown for
approximately seven seconds. Pressing on the
screen time (where the Hold Temperature Until time
is shown) allows the arrows to reappear.
68-0280 26