Operate Your Thermostat; Mount Thermostat To Wallplate; Set Fan And System Switches - Honeywell CT500 Owner's Manual

CT500 ELECTRONIC THERMOSTAT
KEEP WIRING IN
ALTERNATE MOUNTING
SHADED AREA
SCREW HOLE
W
Y
R
WIRING ENTRANCE HOLE
MOUNTING
SCREW HOLE
Fig. 6. CT500 wallplate wiring connections.
Fig. 7. CT500 methods for wiring connection.
5 MOUNT THERMOSTAT TO
WALLPLATE
Align the tab and connector pins at the top of the
thermostat with the wallplate. See Fig. 8.
69-1525—2
MOUNTING
SCREW
HOLE
G
ALTERNATE
MOUNTING
SCREW HOLE
FOR WRAPAROUND, STRIP
7/16 IN. (11 mm)
FOR STRAIGHT INSERTION,
STRIP 5/16 IN. (8 mm)
DASHED LINES INDICATE TABS
ON BACK OF THERMOSTAT
Set
FAN
Auto On
A
ENGAGE TABS AT TOP
OF THERMOSTAT WITH
SLOTS ON WALLPLATE.
M11025B
Fig. 8. Mounting thermostat to wallplate.
M14874
Press the thermostat straight onto the wallplate to
latch.
NOTE: To remove the thermostat from the wallplate,
grasp the thermostat on both sides and pull it
straight out.
Restore power to the heating/cooling system.

6 OPERATE YOUR THERMOSTAT

Display Temperature Setting
a. Press
b. The temperature setpoint and the room tem-
M12537
7 SET FAN AND SYSTEM
SWITCHES
Manually control fan and system settings using the
switches located at the bottom of the thermostat case.
See. Fig. 9 for switch locations.
4
Room
SYSTEM
Cool Off Heat
or once to display present temper-
ature setting.
perature are shown separately on the digital
display. The indicator points to Set when the
temperature setpoint is displayed and to Room
when the room temperature is displayed.
INDICATOR
ROOM TEMPERATURE
Set Room
SETPOINT TEMPERATURE
Set Room
FAN SYSTEM
Auto Cool Off Heat
B
PRESS LOWER EDGE OF
CASE TO LATCH.
M14679