Honeywell VisionPRO 8000 Owner's Manual page 19

VisionPRO TM 8000 Touchscreen Programmable Thermostat
Table 3. Installer Setup Menu. (Continued)
Installer Setup
Number Installer Setup Name Settings Notes
0650 Extended Fan OnTime 0--no extended fan operation after call for heat ends Not shown iffan operation
Heat 90-- fan operation is extended 90 seconds after call for is set to fossil fuel or in
heat ends. Cool Only Systems
0660 Extended Fan On Time 0--no extended fan operation after call for cool ends Not shown in Heat Only
Cool 90--fan operation is extended 90 seconds after call for Systems.
cool ends.
0670 Keypad Lockout
0680
0690
O7OO
0--unlocked keypad
l--partially locked keypad
2--fully locked keypad
Temperature Control in
Heat
Temperature Control in
Cool
Temperature Display
Offset
l--less aggressive temperature control (could cause
temperature undershoot)
2--Standard temperature control in heating (factory
setting)
3--more aggressive temperature control (could cause
temperature overshoot)
l--less aggressive temperature control (could cause
temperature undershoot)
2--Standard temperature control in cooling
(factory setting)
3--more aggressive temperature control (could cause
temperature overshoot)
-3 --°F (-1.5°C)
-2 --°F (-1°C)
-1 --°F (-.5°C)
0 --°F (0. °C) -- (no difference in displayed temperature
and actual room temperature )
I --°F (.5°C)
2--°F (1°C
3 --°F (1.5°C)
Unlocked--all functions
are available.
Partially locked--only
temperature up and down
keys and ability to enter
and modify Installer Setup
mode are available.
Fully locked--only ability
to enter and modify
installer Setup mode are
available.
Applies to recovery ramp
and use of auxiliary heat
during recovery.
Choose 1 if getting
temperature overshoot.
Choose 3 if getting
temperature undershoot.
Applies to recovery ramp.
Choose 1 if getting
temperature overshoot.
Choose 3 if getting
temperature undershoot.
0710 Reset Thermostat 0--no thermostat reset. Only calendar settings
l--resets all Installer Setup Options to default values and and time are retained.
resets schedule to default setting.
19 68-0280