Download Print this page

Advertisement

Quick Links

Description

This programmable thermostat can be used to control an electric
heating system such as an electric baseboard heater, a radiant ceil-
ing, a radiant floor, a convector, etc.
Time and day
Set the day
Set the time
Program the
schedule
Skip a period
Select the
operating mode
Periods
The thermostat cannot be used under the following conditions:
The resistive load is greater than 16.7 A
The resistive load is less than 2 A
The system is driven by a contactor or relay (inductive load)
The system is a central heating system

SUPPLIED PARTS:

One (1) thermostat
Two (2) 6-32 screws
Two (2) solderless connectors

Installation

TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK.
THE INSTALLATION MUST BE PERFORMED BY AN ELECTRI-
CIAN.
All cables and connections must conform to the local electrical
code.
Special CO/ALR solderless connectors must be used when con-
necting with aluminum conductors.
Install the thermostat onto an electrical box.
Install the thermostat about 5 feet high, on an inside wall facing
the heater.
Avoid locations where there are air drafts (such as the top of a
staircase or an air outlet), dead air spots (such as behind a
door), or direct sunlight.
Do not install the thermostat on a wall that conceals chimney or
stove pipes.
The thermostat wires are not polarized; either wire can be con-
nected to the load or to the power supply.
08060 / TH106 / TL6061
Programmable Thermostat - Installation and User Guide
Temperature
preset buttons
Appears when the
setpoint is displayed
emperature
T
Operating
mode icons
Temperature
preset icons
Heating power
indicator
Temperature
adjustment
buttons
NOTE:
Always keep the thermostat's vents clean and unobstructed.
1.
Connect the thermostat wires to the line wires and to the load
wires using solderless connectors for copper wires.

2-wire installation

4-wire installation
2.
Push any excess wire back into the electrical box.
NOTE:
If necessary, before re-installing the front component, config-
ure the thermostat (see section 3).
Return power to heating system.
08160
TH106
TL6160
69-2024
1/11/06
1/3

Advertisement

loading

Summary of Contents for Honeywell 08160

  • Page 1 08160 TH106 TL6160 NOTE: Always keep the thermostat's vents clean and unobstructed. Description This programmable thermostat can be used to control an electric heating system such as an electric baseboard heater, a radiant ceil- ing, a radiant floor, a convector, etc.
  • Page 2 To store the Vacation temperature: Configuration Set the desired temperature using the button. Press and The configuration switches are on the back of hold both buttons simultaneously for approximately 3 the thermostat. The factory settings are indi- seconds until the icon is displayed.
  • Page 3 Thermostat is hot. reach a temperature between 95 °F warranty shall not apply if it is shown by Honeywell that the defect or (35 °C) and 104 °F (40 °C). malfunction was caused by damage which occurred while the prod- uct was in the possession of a consumer.

This manual is also suitable for:

Th106Tl6160