Table of Contents
Advertisement
3.7
Replacing the power supply
Follow these instructions to replace the power supply in your
TX46 system.
1. Remove the front and rear chassis covers as described
in section 2.2.1 Removing the chassis cover.
2. Remove the single screw that secures the grounding wire
to the chassis as shown.
3. Pull the two spade connectors off the terminals on the
back of the AC power socket.
4. Remove the two screws that secure the power supply to
the chassis and lift the unit free.
5. Secure the new unit in place with two screws, reconnect
the spade connectors on the AC power socket and
reconnect the grounding wire to the chassis.
Note:
that the grounding wire is connected to the
chassis.
Chapter 3: Replacing pre-installed components
For safety reasons, it is essential
3.7 Replacing the power supply
39
Advertisement
Table of Contents
