3.3 Replacing the slim CD-ROM drive
4. Carefully lift the motherboard from the chassis.
Note:
straight out. Lift the front edge of the mother-
board up to an angle of about 45°. Then slide
the motherboard out, front end first.
3.3
Replacing the slim CD-ROM drive
This section describes how to remove and replace the CD-
ROM drive in your TX46 system.
1. Remove the front and rear chassis covers as described
in section 2.2.1 Removing the chassis cover.
2. Locate the drive bay housing the slim CD-ROM drive and
remove the power and data cables from the backplane.
32
The motherboard is too large to lift
Chapter 3: Replacing pre-installed components