Xerox 6204 Wide Format Solution User Manual page 264

Problem Solving
Symptoms Check
The scanned
image is too
light.
The scanned
images are
skewed.
Part of the
original image is
not present on
the scanned
image.
The scanned Is the original pasted
image has together or folded in?
shadows.
Is the original made of
highly transparent material?
The scanned Is the scan resolution set too
image is coarse. low?
Did you select the correct
rendering setting?
10- Xerox 6204 Wide Format Solution
192 User Guide
Is the density of the
original too light?
Is the scan density set to
[Lighten]?
Is the original type
setting correct?
Was the original loaded
correctly in the scanner?
Is the original guide in
the correct position?
Was the original loaded
correctly in the scanner?
Are the scan feature
settings copy density,
media supply, margins,
and scan offset correct?
Remedy
Adjust the scan density.
Refer to the section on Scan Density.
Select the correct original type.
Refer to the section on Original Type.
Load the original correctly.
Refer to Step 3 - Scanning the Document.
Correctly load the original, with the edge of the
original aligned with the original guide.
Refer to Step 3 - Scanning the Document.
Load the original correctly.
Refer to Step 3 - Scanning the Document.
Correctly configure these settings.
Adjust the scan density and original type settings.
Refer to the section on Original Type.
Select a higher resolution.
Refer to the section on Scan Resolution.
Select the correct rendering setting.
Refer to the section on Rendering.