Nautilus Be strong NS 600X Assembly Manual page 16

STEP 8
NS600X Press Arm
B
Step 8 Components:
# Component
30 Pec Fly Double Floating Pulley Bracket
44 4 1/2" Pulley
54 Cable #2 - Mid-Pulley Cable
63 Hex Bolt 3/8" x 2 3/4"L
64 Hex Bolt 3/8" x 2 1/4"L
74 3/8" Flat Washer
77 3/8" Lock Nut
80 Step Spacer 1"H
81 Step Spacer 21/32"H
16
ASSEmBLY
Procedure:
a. Attach Two 4 1/2" Pulleys (44) to the brackets shown in detail A using the hardware
Qty
shown. Tighten hardware securely.
1
B. Remove the Ball, Washer, and U-Bracket from one end of Cable #2 (54).
2
c. Attach looped end of Cable #2 (54) to the Pulley Mount bracket using the hardware
1
shown in detail A.
2
1
D. Route Cable #2 (54) around the 4 1/2" Pulley located on the Leg Extension
2
assembly and around the 4 1/2" Pulley on the Pulley Mount Bracket. Proceed by
3
routing the Cable around the lower Pulley on the Double Floating Pulley Bracket
2
(30) as shown.
2
e. Route Cable #2 (54) around the 4 1/2" Pulley on the Pec Fly Double Floating Pulley
Bracket (30). Continue by routing Cable over the 3 1/2" Pulley in the bracket on the
Front Upright and over the 4 1/2" Pulley adjacent to it.
f. Re-install the Ball, Washer, and U-Bracket to the end of the cable. Be sure that the
rubber o-ring is in its original position.
96.75" (2460mm)
54
30
C
77
80
74
A
44
81
63
2 3/4"L
64 2 1/4"L