Nautilus Be strong NS 600X Assembly Manual page 14

STEP 6
Step 6 Components:
# Component
32 Guide Rod Holder
48 Top Weight Assembly
49 Weight Plate
50 Weight Stack Bottom Plate
51 Weight Stack Cushion
52 Guide Rod
68 Cap Head Allen Bolt 1/4" x 1"L
Threadlock
90 Weight Selector Pin
1
ASSEmBLY
Procedure:
Qty
a. Slide Weight Stack Cushion (51) on each Guide Rod (52) allowing approximately
1
3 inches of Guide Rod showing below the Weight Stack Cushion (51). Insert
1
Guide Rods (52) into holes in the Calf Raise/Low Pulley Frame as shown.
19
B. Slide Weight Stack Bottom Plate (50) on top of Weight Stack Cushions (51).
1
c. Place Nineteen Weight Plates (49) and the Top Weight Assembly (48) on the
2
Guide Rods (52) as shown. Install Weight Plates (49) so that the selector pin hole
2
faces forward and is located on the bottom of the plate. Install the Top Weight
2
Assembly (48) so that the head of the bolt is facing forward. This gym is supplied
1
with individual weight plate numbering decals that should be applied to the gym
after the weight stack is assembled.
D. Slide Guide Rod Holder (32) on the top of the Guide Rods (52) and attach the
Guide Rod Holder (32) to the Top Stack Support Frame using the hardware shown.
Tighten hardware securely.
e. Place Weight Selector Pin (90) in the bottm Weight Plate (49).
32
52
68 1"L
48
49
50
90
51