Nautilus Be strong NS 600X Assembly Manual page 18

STEP 10
1 1/2"L 67
1 3/4"L 70
74
74
77
Step 10 Components:
# Component
33 Low Pulley Cover
44 4 1/2" Pulley
56 Cable #4 - Pec Fly Cable
67 Hex Bolt 3/8" x 1 1/2"L Threadlock
70 Button Head Screw 1 3/4"L
74 3/8" Flat Washer
77 3/8" Lock Nut
18
ASSEmBLY
33
74
21
74
77 74
Procedure:
a. Attach two 4 1/2" Pulleys (44) to either side of the Leg Extension Assembly using
Qty
the Low Pulley Cover (33) and the hardware shown. Note the orientation of the
2
Low Pulley Covers. Tighten hardware firmly.
2
B. Attach the Cable #4 (56) termination to the left Pec Fly Cam using the hardware
1
2 shown. Be sure to place the groove in the termination bracket against the cam.
2
Tighten hardware securely.
6
c. Remove the bracket and spacer from the other end of Cable #4 (56). Route the
2
Cable around the left Pulley in the Pec Fly Pulley Bracket (21) as shown. Proceed
by routing the Cable around the Pulley on the left side of the Leg Extension
Assembly as shown. Be sure that the Low Pulley Cover (33) does not interfere with
the Cable.
D. Route Cable #4 (56) around the 6" Pulley in the Pec Fly Double Floating Pulley
Bracket (30) and around the Pulley on the right side of the Leg Extension Assembly
as shown. Be sure the Low Pulley Cover (33) does not interfere with the Cable.
e. Route Cable #4 (56) around the right Pulley in the Pec Fly Pulley Bracket (21) as
shown, and attach the cable termination to the right Pec Fly Cam using the
hardware shown. Be sure to place the groove in the termination bracket against
the cam. Tighten hardware securely.
NOTE: If the cable termination does not reach the connection hole on the cam,
adjust the Pulleys in the Double Floating Pulley Brackets to increase cable length.
30
56
44
1 3/4"L
70
74
122.5" (3110mm)
33
1 1/2"L
67