Nautilus Be strong NS 600X Assembly Manual page 17

STEP 9
NS600X Press Arm
Step 9 Components:
# Component
55 Cable #1 - Low Row
60 Hex Bolt 3/8" x 4"L
74 3/8" Flat Washer
77 3/8" Lock Nut
78 Pulley Spacer 1"L
ASSEmBLY
Procedure:
a. Remove the lower Pulley from the Double Floating Pulley Bracket (31). Loop
Qty
Cable #3 (55) around the Pulley and re-install the Pulley as shown. Tighten
1
hardware firmly.
1
B. Wrap Cable #3 (55) under the Cable Housing (9) and attach the termination to
2
the Rear Frame using the hardware shown in detail A. Do NoT oVerTiGHTeN.
1
1
NoTe: Make sure to route Cable through the hole in the Pulley Mount tube.
NoTe:
This Cable termination is used for exercise attachments such as the NS-75.
If an attachment is used, do not install Cable Housing (9). Please refer to
attachment instructions for installation.
31
55
C
74
77
78
9
A
Nautilus NS600X
60
4"L
74
17