Nautilus Be strong NS 600X Assembly Manual page 19

STEP 11
attach accessories
A. Attach the Handles, Lat Bar, Ankle Cuff, Shoulder Straps,
and Ab Strap to the cable ends using the Cable Clips.
lubrication and final check
A. Lubricate Guide Rods and Guide Tubes using a silicon based
lubricant.
B. Carefully inspect all cables and insure that they are properly
seated on the pulleys and that they pass between the cable
stops and pulleys.
C. Double check all hardware and make sure everything is
tightened properly.
cable Tensioning
A. Tighten the Cable System using the combination of four
adjustment locations.These locations are the Double Floating
Pulley Brackets and the Selector Rod Top Plate Assembly.
The Cable System should be tightened as tight as possible yet
still allow the Selector Pin to freely engage all weights.
B. After the cables are tensioned, load the gym with as high a
weight as you feel comfortable with and pull each cable several
times to set and stretch the cables.
C. After the cables are set and stretched, the Cable System may
need to be re-tensioned. Tension the cables as described in
Step A.
D. The cables may need to be tensioned periodically as they may
stretch slightly over time.
ASSEmBLY
Nautilus NS600X
19