Pass/Fail - Rigol DS1000CA series User Manual

RIGOL

Pass/Fail

The Pass/Fail function monitors changes of signals and output pass or fail signals by
comparing the input signal is within the pre-defined mask. The testing results not
only can be displayed on screen or output by isolated pass/fail port but also can be
alarmed if turn on system sound.
Press Utility→Pass/Fail to go to the following menu.
Figure 2-84 Table 2-51 The Pass/Fail menu (Page 1/2)
Figure 2-85 Table 2-52 The Pass/Fail menu (Page 2/2)
Note: [1] Only available when sound is enabled.
2-64
Menu Setting
ON
Enable Test
OFF
CH1
Source
CH2
(RUN)
Operate
■
ON
Msg display
OFF
Menu Settings
Fail
Fail +
Output
Pass
Pass +
Stop ON
on Output OFF
Mask
Setting
Turn on Pass/Fail test.
Turn off Pass/Fail test.
Select Pass/Fail test on CH1.
Select Pass/Fail test on CH2.
Pass/Fail test stopped, press to run.
Pass/Fail test running, press to stop.
(STOP)
Turn on Pass/Fail information display.
Turn off Pass/Fail information display.
Output when Fail condition detected.
[1] Output and beep when Fail condition
detected.
Output when Pass condition detected.
[1] Output and beep when Pass condition
detected.
Stop test when output occur.
Continue test when output occur.
Go to mask setting menu.
Comments
Comments
User‟s Guide for DS1000CA Series