Function Check - Rigol DS1000CA series User Manual

Function Check

Perform this quick functional check to verify that the instrument is operating
correctly.
1. Turn on the instrument
Use the power cord designed for the oscilloscope to connect the instrument and
AC power which delivers 100 to 240 VAC
switch to turn on the instruments, waiting until the display shows the waveform
window.
2. Recall factory setting
Press Storage → Storage → Factory → Load, to recall factory setting.
WARNNING
!
To avoid electric shock, be sure the oscilloscope is properly grounded.
3. Input a signal to a channel of the oscilloscope
Push BNC plug of probe into CH1 BNC connector, then twist the BNC cable to

right to lock the probe in place. Switch on the probe to 10X.
User‟s Guide for DS1000CA Series
Power Switch
Figure 1-4
Turn on the instrument
, 45Hz to 440Hz. Press the power
RMS
Storage Button
RIGOL
1-7