To Understand The Horizontal System - Rigol DS1000CA series User Manual

To Understand the Horizontal System

See figure 1-9 as below, the HORIZONTAL Control Area contains a button and
two knobs, which are not only used to set up horizontal parameters and timebase,
but also to adjust horizontal position of waveforms.
1. The horizontal
waveform window.
Turning the horizontal
right and a sign at the left-bottom of the screen will vary to show the horizontal
position of the waveform.
Horizontal offset back to 0 shortcut key
Press the
key, this is especially helpful when the trigger point is far out of the screen
and want it to get back to the screen center immediately.
2. Press MENU button to display "Time" menu, setting delayed state, time base
mode and trigger offset.
User‟s Guide for DS1000CA Series
Figure 1-9 Horizontal Control
knob adjusts signal horizontal position on
knob, the waveform will move to left or
knob to set the horizontal offset to 0 as a shortcut
RIGOL
1-13