To Set Up The Horizontal System - Rigol DS1000CA series User Manual

RIGOL

To Set Up the Horizontal System

Press MENU button to enter the horizontal setting system.
Figure 2-31 Table 2-16 The Horizontal menu
NOTE:
[1] No trigger or horizontal offset control of waveforms is available
Term Explanations:
Slow Scan Mode: This mode is available when the horizontal time base is
set to 50ms or slower. In this mode, the oscilloscope acquires sufficient
data for the left part to the trigger point, then wait for trigger, when trigger
occurs, it continue to draw the rest part from the trigger point to the end of
the right side. When choosing this mode to view low frequency signals, it is
recommended that the channel coupling should be set as DC.
2-26
Menu
Delayed
Time Base
Trig-offset Reset
during Roll Mode, and it‟s only available when set to 500ms/div
or slower.
Settings
ON Turn on Delayed Scan mode.
OFF Turn off the Delayed Scan mode.
Y-T Y-axis indicates vertical voltage,
X-axis indicates horizontal time.
X-Y Y-axis indicates voltage of CH2,
X-axis indicates voltage of CH1.
[1]
Roll The waveform display updates
from right to left.
Reset Adjust to the center.
User‟s Guide for DS1000CA Series
Comments