Edge Trigger - Rigol DS1000CA series User Manual

Edge Trigger

An edge trigger determines whether the oscilloscope finds the trigger point on the
rising or the falling edge of a signal. Select Edge trigger Mode to trigger on Rising
edge, falling edge or rising & falling edge.
Press MENU→Mode→Edge to enter the following menu.
Figure 2-35 Table 2-17 The Trigger menu
Menu
Source
Slope
Sweep
Set up
User‟s Guide for DS1000CA Series
Settings
CH1 Select CH1 as trigger signal.
CH2 Select CH2 as trigger signal.
EXT Select EXT TRIG as trigger signal.
EXT/5 Select attenuated EXT TRIG/5 as trigger
signal.
AC Line Select power line as trigger signal.
Trigger on rising edge.
Trigger on falling edge.
Trigger on both ring & falling edge.
Auto Acquire waveform even no trigger occurred.
Normal Acquire waveform when trigger occurred.
Single When trigger occurs, acquire one waveform
then stop.
To go to Set Up menu, see table 2-32
Comments
RIGOL
2-31