Read Mode Settings - Opticon OPT-6125 Series User Manual

Manual No. 25-ULGPMU01-01
CCD Scanner

Read Mode Settings

Single Read - When a bar code has been decoded, the reader will be turned OFF. The reader must be triggered again
to read another label. This option and "Disable trigger" cannot be programmed at the same time.
Multiple Read - When a bar code has been decoded, the reader will stay ON for a time as set by "read time
settings" or indefinitely if the trigger switch has been disabled. The same label can only be decoded again after the
label has not been detected for a number of scans.
Continuous Read - The reader will produce as much data as it can decode regardless whether it is the same or not.
This mode is mainly used for demonstration and diagnosis.
Add-on Wait Mode - Used if UPC/EAN with add-on is enabled. The reader searches within the selected time for a
valid add-on code. If a valid add-on code is found, the reader transmits the data immediately. If nothing is found
behind the code, the scanner will transmit the data without add-on. If something is found behind the code, the reader
ignored the code in case it is not a valid add-on.
Start/End
-[[-
ZZ
Program
Menu
-T1-
Single
S0
read
-T2-
Multiple
S1
read
-T3-
Continuous
S2
read
Add-on
-YB-
XA
wait mode
disabled
Add-on
-TC-
XB
wait mode
0.25 sec.
Add-on
-YD-
XC
wait mode
0.50 sec.
Add-on
-YE-
XD
wait mode
0.70 sec.
Series OPT Handheld
Page 57