Selecting The Read Mode - Opticon LMD 1135 User Manual

Manual No. 25-ULPNR102-01; Mar, 2005

28. Selecting the Read Mode

Computer
Command
(ZZ)
S0
S1
S2
The operation of the scanner in the various read modes is described in the table below. The "Continuous
Read" mode is helpful in positioning the scanner for optimum reading. In "Continuous Read," the
scanner's buzzer functions like a Geiger counter, sounding the most active at the position achieving the
greatest number of good reads.
Mode
Multiple
Read
Continuous
Read
Single
Read
Function
/Description
START/END
Programming Menu
Single Read Mode
(Trigger enabled mode only)
Multiple Read Mode
Continuous Read Mode
Trigger Function Enabled (S8) Trigger Function Disabled (S7)
After receiving a trigger pulse,
scanner will read multiple,
different bar codes in succession
until it times out. (Each read will
reset the scanner's time out)
Scanner may not read the same
bar code twice if they are
consecutive. (See Sect. 32)
Scanner will read the same bar
code continuously after receiving
a trigger pulse until the label is
removed, the laser then times
out.
Scanner will read only one bar
code after receiving a trigger
pulse. The scanner time out is
terminated on a good read and
the laser turns off.
LMD 1135 Laser Fixed Mount Scanner
Bar Code
Command
[[
T1
T2
T3
Scanner will read different bar codes
in succession if they are presented
to the read window.
Scanner may not read the same bar
code twice if they are consecutive.
(See Sect. 32)
Scanner will read the same bar code
continuously.
Same as Multiple Read mode,
above.
Page 59