Reset All Defaults; Computer Type Selection - Opticon OPT-6125 Series User Manual

Manual No. 25-ULGPMU01-01
Reset All Defaults – Keyboad Wedge Interface
Our scanners are shipped with factory default settings that represent the settings most commonly used by our customers. In most
applications, the scanner will work right out of the box without any need for additional programming. At any time you can return
the scanner to the factory default settings by scanning the "Reset all Defaults" programming bar code below.
NOTE: ( ) A pointing finger indicates default settings throughout the following menus.
Computer Type Selection (for Keyboard Wedge only)
The Keyboard Wedge interface scanner is designed to operate with an IBM personal computers and compatibles along with a
Macintosh PC's. Select the host computer type from the menu below.
NOTE: If the scanner has not been set to the correct host computer, the scanner will display random characters on the screen after
reading a bar code label.
Start
ZZ
Program Menu
UA
XT Wedge
UB
AT Wedge
UC
PS2 wedge
End
ZZ
Program Menu
Start
ZZ
Program
Menu
K0
IBM PC/XT
IBM AT
&
K1
compatibles
K3
HP Vectra
K4
Macintosh
End
ZZ
Program
Menu
-[[-
-VB-
-VC-
-VD-
-[[-
-[[-
-L1-
-L3-
-L!-
-L5-
-[[-
Series OPT Handheld CCD Scanner
Page 6