Attaching Door; Parts For Door Assembly; Pan Head Screw; Plastite Screw - Craftsman 113.197250 Operator's Manual

35. Adjust the lower nut with the 9/16 inch
wrench until the levelingJoot is at the desired
height.
36. Tighten the top nut by hand.
37. Repeat steps 33-36 for the other three
leveling feet if necessary.
38. Tighten all four bottom nuts using a 9/16
inch wrench.
Attaching Door
Fig. 27 - Pan Head Screw
3. Attach the door to the hinges on the side
panel using four plastite screws. Tighten with
a Phillips screwdriver. (Figure 28)
Magnetic Catch
/
Magnetic Stop Plate
Fig, 25 - Parts for Door Assembly
1. Put a magnetic catch on the inside edge of
the door. (Figure26)
2. Fasten using two pan head screws. Tighten
with a Phillips screwdriver. (Figure 26 & 27 )
Door
/
1
d
Magnetic Catch
Fig. 28 - Plastite Screw
4. Attach a magnetic stop plate to the two
small holes on the side of the front support
using four pan head screws. Tighten with a
Phillips screwdriver. (Figures 29 & 30)
Front Support
o
o
-4-- Magnetic Stop Plate
Pan Head Screw
Fig. 29
Fig. 30 - Pan Head Screw
Fig. 26
16
/