Craftsman 113.197250 Operator's Manual page 14

15. Attach two hinges to the right side panel
above the spacer, using four truss head bolts,
lockwashers, and hex nuts. Tighten with a
7/16 inch wrench. (Figure 19)
Fig. !9
Spacer
.,..---- Right Side
Panel
16. Lay the shelf on the rear edge with the
bottom side toward you. The angled end of
the lower support should point up.
17. Place the right side panel on the right
side of the shelf. The _pacer should be on the
inside of the cabinet. (Figure 20)
Corner Brackets
18. Put truss head bolts through the three
holes along the bottom edge of the right side
panel. Put a lockwasher and hex nut on each
bolt and tighten using a 7/16 inch wrench or
socket. (Figure 20)
Note: It is sometimes difficult to get bolts
through these three holes. You may need to
use a Phillips screwdriver to help shift the
parts into place.
19. Repeat steps 17-18 with the left side
panel and the left side of the shelJ:
20. Turn the cabinet right side up. Attach the
skirts to the top of the side panels, with one
on the front of the cabinet and the other on
the back. (Figure 21)
Rear Skirt
ht Side Panel
\
\
\\
Left Side
Panel
Fig. 21
Shelf
Front
Skirt
Shelf
Shelf Stiffener -_ Right Side
Panel
Rear Flange "_
Fig. 20
21. Use eight truss head bolts, lockwashers,
and hex nuts to hold the skirts in place. Hand-
tighten. (Figure 21)
22. Put a truss head bolt through the hole at
the back, right corner of the shelf. This hole
goes through the shelf and the right side
panel. (Figure22)