Table of Contents
Advertisement
Available languages
Available languages
ATTACHING
THE BLADE
See Figure 2, page L
A
WARNING:
A 6-1/2 in. blade is the maximum blade
capacity of the saw. Never use a blade that is too
thick to allow outer blade washer to engage with the
flats on the spindle. Larger blades will come in con-
tact with the blade guard, while thicker blades will
prevent blade screw from securing blade on spindle.
Either of these situations could result in a serious
accident.
•
Remove the battery pack from the saw.
•
Remove blade wrench (5 mm hex key) from storage
area.
•
Depress spindle lock button and remove blade screw
and outer blade washer.
NOTE: Turn blade screw clockwise to remove.
NOTICE:
To prevent damage to the spindle or
spindle lock, always allow motor to come to a
complete stop before engaging spindle lock.
NOTE: Do not run the circular saw with spindle lock
engaged.
•
Wipe a drop of oil onto inner blade washer and outer
blade washer where they contact blade.
A
WARNING:
If inner blade washer has been
removed, replace it before placing blade on spindle.
The larger diameter of the inner blade washer should
be placed against the blade. Failure to do so could
cause an accident since blade will not tighten
properly.
•
Fit saw blade inside lower blade guard and onto
spindle.
NOTE: The saw teeth point upward at the front of saw
as shown in figure 2.
•
Replace outer blade washer.
•
Depress spindle lock button, then replace blade screw.
Tighten blade screw securely by turning counterclock-
wise.
•
Return blade wrench to storage area.
NOTE: Never use a blade that is too thick to allow the
outer blade washer to engage with the flats on the
spindle.
REMOVING
THE BLADE
See Figure 3, page i.
•
Remove the battery pack from the saw.
•
Remove blade wrench from storage area.
•
Position the saw as shown, depress the spindle lock
button, and remove the blade screw by turning it
clockwise.
•
Remove outer blade washer.
•
Remove the blade.
8 - English
Advertisement
Table of Contents
