Leveling Table Supports - Craftsman 113.197250 Operator's Manual

,0" "
Leveling Table Supports
1. Raise the radial arm until the bottom of
the motor is about 2-1/2 inches above the
saw.
2. Locate four hex head bolts and put a flat
washer on each.
3. Attach a table support to each side of the
saw using the four hex head bolts and flat
washers. (Figure 58 & 59) Put the bolts
through the center of the enlarged holes in the
table supports so that the supports may slide
up or down as needed.
LOCKWASHER
TABLE NUT
SUPPORT TABLE
)RT
SCREWS
HERE
\
\
HEXHEADSCREW
5/16-18X3/4
Fig. 58
MOUNT RAILS USING
THESE HOLES
FRONT
Fig. 59 - Hex Head Bolt, Washer, Lockwasher
and Hex Nut
4. Put a lockwasher and hex nut on each bolt
and hand-tighten.
5. Unlock the bevel lock to release the motor.
Hold onto the motor as you do this.
CAUTION: The motor is heavy and
can swing down quickly. You can be cut
or injured if the arbor shaft hits you. Hold
the motor when you unlock the bevel lock.
6. Turn the motor until the arbor shaft is
pointing straight down toward the saw.
(Figure 60)
Arbor Wrench
Rear Bolt
Fig. 60
7. Lock the bevel lock to hold the motor in
this position.
8. Unlock the miter lock and move the arm to
the left as far as it will go (about 50 ° miter).
9. Unlock the rip lock and move the motor
until the arbor shaft is over the left table
support. (Figure 60)
!0. Mark the point on the table support un-
der the center of the arbor shaft.
11. Place the arbor wrench over this point
and lower the arm until the arbor shaft is just
touching the wrench. The wrench should slide
back and forth with slight contact. (Figure 60)
12. Tighten the rear bolt under this point
using a 1/2 inch wrench.
13. Move the arm and motor until the arbor
shaft is over the front bolt on the left table
support. Do not change the elevation of the
arm as you move from point to point.
(Figure 61)
55