Craftsman 113.197250 Operator's Manual page 13

3. Put two truss head bolls through the shelf
and each corner bracket to hold the brackets
in place•
4. Put a lockwasher and hex nut on each bolt
and tighten with a 7/16 inch wrench or
socket.
5. Put the shelf stiffener on the shelf and line
up the holes. (Figure 16)
Shelf Stiffener
Fig. 17
9. Turn the right side panel so that the J-
shaped slot is at the bottom and facing you.
10. Put a spacer inside the right side panel as
shown. The side of the spacer with two round
holes should be opposite the J-shaped slot in
the side panel, and the side with one larger
hole should be on the bottom. (Figure 18)
Fig. 16
Truss Head Bolt
--_ Lockwasher
Hex Nut
6. Put the casters (wheels) on the shelf and
shelf stiffener. Since the shelf is upside down,
the wheels will point up. Line up four holes
on each side. (Figure 16)
7. Put truss head bolts through the holes on
each side. Put a lockwasher and hex nut on
each bolt and tighten using a 7/16 inch
wrench or socket.
Spacer
_und_H_ i )
One Larger Hole
Fig. 18
Right Side Panel
-Shaped Slot
11. Put two truss head bolts through right
side panel and spacer, one on each side.
12. Put a lockwasher and hex nut on each
bolt and tighten using a 7/16 inch wrench or
socket.
8. Find the right and left side panels. Look
carefully to find the "R" and "L" stamped
in the metal near the center of the wide edge.
These stamps are the easiest way to tell the
right side panel from the left. (Figure ! 7 )
13. Put aplastic cover over the J-shaped slot
in the side panel. (Figure 18)
14. Repeat steps 9-13 with the left side
panel.
13