Attaching Trim Caps And Trim Ledge; Attaching The Handwheel - Craftsman 113.247440 Owner's Manual

ATTACHING TRIM CAPS & TRIM LEDGE
1 Locate the two (2) trim caps, the trim ledge, and
from loose parts bag six (6) screws 1/4 x 1/2
2. Place the trim ledge against the bottom of the
base, then reach through the base and secure the
trim ledge with the two screws using a phillips
screwdriver
PHI LLIPS SCREWDRIVER
TRIM LEDGE
3 Position the trim caps in place and hold as
illustrated
4. Then reach through the base and secure the trim
cap with the two (2) screws using a phillips
screwdriver Repeat procedure for other side
ATTACHING THE HANDWHEEL
1. From loose parts bag find one (1) pan head screw
10-32 x 2 and one (1) hex nut lnstaH the hand-
wheel Reach inside the base to the back side of
the bevel mechanism and put the nut in place
Hold the nut in place with a finger Install the
screw through the center of the handwheer and
tighten with a phillips screwdriver.
2 Hold the handle and pull the red release button
with your finger to ciose the handle
15