Setting Zero References - Craftsman 113.197250 Operator's Manual

22.
If the display is still not correct, repeat
steps 15 - 21 until the bevel encoder is in the
right position, or
8. Push the ELEVbutton.
9. Push the REF SETbutton.
If the display is correct, go to the next section.
Setting Zero References
Bevel, Miter and Elevation
The "0" reference points for miter, bevel, and
elevation are usually set with the:
.Saw in the crosscut position with the
radial arm perpendicular to the fence
(0° miter).
10. The display will say:
In-rip Reference
The "0" reference point for in-rip is usually
set with the blade just touching the front of
the fence.
1. Unlock the swivel lock.
• Blade perpendicular to the fence and
front table (0 ° bevel).
•Blade in front of the fence just touching
the front table (0 inches elevation).
2. Turn the motor to the in-rip position with
the blade between the motor and the fence.
3. Lock the swivel lock.
4. Unlock the table locks and put the fence
between the front table and the spacer.
You may set the "0" reference points in this
position, or any other position you choose.
1. Put the blade in the position you have
chosen to be the zero reference point.
2. Push the MITER button.
3. Push the REF SETbutton.
4. The display will say:
MIT • U
5. Push the BEVEL button.
6. Push the REF SET button.
7. The display will say:
BEV • U
44
5. Lock the table locks.
6. Unlock the rip lock.
7. Move the motor back until the blade is just
touching the front of the fence.
8. Lock the rip lock.
9. Push the RIP button.
10. If the display shows the RIP function, go
to step 11, or
If the display shows the O-RIP function, push
the RIP button again. Then go to step 11.
11. Push the REF SETbutton.
12. If the display says:
1 "hi
.,P .U U