Advertisement
Manycoverplatescrews, waterpipesandoutletboxes
arenotproperly g rounded. Toensure proper g round,
grounding means mustbetestedbya qualified electri-
cian.
EXTENSION
CORDS
° The use of any extension cord will cause some drop
in voltage and loss of power.
.
Wires of the extension cord must be of sufficient size
to carry the current and maintain adequate voltage.
.
Use the table to determine the minimum wire size
(A.W.G.) extension cord.
.
Use only 3-wire extension cords having 3-prong
grounding type plugs and 3-pole receptacles which
accept the tool plug.
.
If the extension cord is worn, cut or damaged in any
way, replace it immediately.
EXTENSION CORD LENGTH
Wire Size
A.W.G.
Up to 50 ft ..................................
16
NOTE: Using extension cords over 50 ft. long is not
recommended.
Circuit
Switch
Breaker
J_
Yellow
Red
#6
L1
115V
Black
White
#5
L/
L2
White
Black
Yellow
#5
230 V
[_1
Figure 5 - Wiring Diagram
#6
Red
l!
1_2
Refer to Figures 6 - 11.
The Craftsman 15" Metal/Wood Cutting Band Saw is for
cutting ferrous and non-ferrous metals and also hard
and soft woods. The band saw features a unitized frame
of welded steel construction and a solid cast iron work
surface to ensure durability. Table tilts 45 ° and has a
miter gauge and precision machined rip fence for per-
forming many different operations. Fifteen inch bal-
anced cast iron wheels with ball bearings and rubber
treads accommodate
blade widths up to 3/4". A conve-
nient tensioning and tracking mechanism makes blade
changing quick and easy.
SPECIFICATIONS
Depth of throat ............................
14%"
Maximum depth of cut .......................
83/4"
Table size .............................
15 x 15"
Table tilt ..............................
-5 to 45 °
Wheel diameter
............................
15"
Blade length ..............................
111"
Blade range ...........................
107-111"
Blade width .............................
3A6 to ¾
Blade speeds ..........
80, 150, 200 and 2,800 FPM
Overall dimensions ..................
68 x 27 x 22"
Shipping weight .........................
215 Ibs
Dust collection port ...........................
4"
CAUTION:
Always observe the following safety
precautions:
° Make sure that blade guides and thrust bearings are
positioned and adjusted correctly to prevent side-
ways and rearward movement of the blade. Adjust
upper guide to just clear workpiece.
° Check to make sure blade is tensioned and tracking
properly. Do not over tension the blade in order to
prevent premature blade wear and breakage. Avoid
under tensioning to eliminate back and forth, side to
side blade movement as it cuts.
•
Use proper blade and speed for the cutting operation.
• After turning saw on, allow blade to come to full
speed before attempting any cutting operation.
•
Support workpiece properly and use a smooth
steady feed to guide work through the cut. Use push
sticks or push blocks when required.
•
Keep hands away and out of line with moving parts.
• Always wear eye protection.
6
Advertisement
