Download Print this page

Extension Cords; Service Safety - Craftsman Professional 320.27311 Operator's Manual

15 amp 7 1/4-in, circular saw with laser trac
Hide thumbs

Advertisement

EXTENSION CORDS
Use a proper extension cord. ONLY use cords listed by Underwrilers Laboratories
(UL). Other extension cords can cause a drop in line voltage, resulting in a loss of
power and overheating of tool.. For this tool an AWG (American Wire Gauge) size of
at least 14-gauge is recommended for an extension cord of 254£ or less in length
Use 12-gauge for an extension cord of 50-ft. Extension cords 100-ft, or longer are not
recommended.
Remember, a smaller wire gauge size has greater capacity than
a larger number (14-gauge wire has more capacity than 16-gauge wire; 12-gauge
wire has more capacity than 14-gauge).. When in doubt use the smaller number
When operating a power tool outdoors, use an outdoor extension cord marked
"W-A" or "W". These cords are rated for outdoor use and reduce the risk of electric
shock.
Z_ CAUTION:
Keep the extension cord clear of the working
area. Position
the cord so that it wilt not get caught on lumber, tools or other obstructions
while you are working with a power tool.
z_WARNING:
Check extension cords before each use. If damaged
replace immediately.
Never use tool with a damaged cord since touching the
damaged area could cause electrical shock, resulting in serious injury.
SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following
symbols.
V...............................................................................................
Volts
A....................................................................................................
Amps
Hz ..........................................................................................................
Hertz
W ......................................................................................................
Watts
min ..............................................................................................
Minutes
,-..... . ................................................................................................
Alternating current
...................................................................................
Direct current
no ............................................................................................
No-load speed
[] ............................................................................................
Class II construction, Double Insulated
Jmin ..........................................................................
Revolutions or Strokes per minute
Z_...........................................................................................
Indicates danger, warning or caution.
It means attention! Your safety is involved..
SERVICE SAFETY
I.. If any part of this saw is missing or should break, bend, or fail in any way;
or should any electrical
component fail to perform properly:
SHUT OFF
the power switch and remove the saw plug from the power source and have
the missing, damaged or failed parts replaced BEFORE resuming operation.
2_.Tool service
must be performed
only at a Sears Parts and Repair Center.
Service or maintenance performed by unqualified personnel could result in
a risk of injury,
3,. When servicing
a tool, use only identical
replacement
parts. Follow
instructions
in the maintenance
section
of this manual. Use of unauthorized
pads or failure to follow maintenance instructions may create a risk of electric
shock or injury.

Advertisement

loading

  Related Manuals for Craftsman Professional 320.27311