Mounting Switch - Craftsman 113.298760 Owner's Manual

MOUNTING SWITCH
t From among loose parts find the following:
2 Hex Head Screws, 5/16-18 x 3/4 in. long
2 Flatwashers (dia. of hole 21/64 in )
2 External Lockwashers
2 Hex Nuts, 5/16-18
2 Insert two 3/4 inch screws through two flat
washers then through holes in switch.
3 Insert screws through holes eight and ten in front
fence guide bar as illustrated.
4 tnstall two lockwashers and nuts Tighten nuts
JAM NUT
5/16-18
1
,@ ,_ iLOCKWASHER
(_ \_ \ • 8TH HOLE
t_\ _ _\ FRONT FENCE
10TH HOLE _ GUIDE BAR
_,L_JL_ (UPSIDE DOWN)
HEX HEAD SCREW
5/16-18 x 3/4 IN_
INSTALLING RIP FENCE GUIDE BARS
1. From among tile loose parts find the following
hardware:
2 Hex Head Screws, 5/16-18 x 1-3/4 in long
2 Hex Head Screws, 5/16-18 x 1 in. long
4 External Lockwashers, 5/16 in
(approx dia. of hole 5/16 in )
4 Hex Nuts, 5/16-18
(approx dia. of hole 5/16 in.)
2 Spacers, 3/4 in. dia x 1/2 in long
2 Self-threading nuts
1 Fence Guide Bar Rod
2 Lay guide bars on saw table.
NOTE: The various holes in the bar allows them
to be positioned on this saw and also makes
them adaptable to other models
3 insert a 1-3/4 inch long screw through the
THIRD hole IN THE FRONT BAR as illustrated
Insert another 1-3/4 inch long screwthrough
ihe SEVENTH hole in bar.
4. Place spacers on screws
LEFT SIDE OF
FRONT GUIDE BAR
(GUIDE BAR IS TO BE
7TH HOLE TURNED END FOR END
3RD HOLE AFTER SCREWS ARE
INSTALLED)
HEX HEAD
SCREW
5/16-18 x I-3/4 IN,
5 Turn front bar end for end and insert bolts
through holes in middle and on right sides of
front of saw table as illustrated . instalt
tockwashers and nuts DON'T SCREW NUTS
ON ALL THE WAY, just get them started on the
SCr ews
6 Insert 1 in long screws in SECOND and
FOURTH or FIFTH holes of rear bar and attach
to table the same way as front bar
7. Insert ends of FENCE GUIDE BAR ROD
through holes in bars as illustrated
NOTE: The ends of the ROD are not threaded ....
the SELF THREADING NUTS will cut threads
on the rod as they are screwed on Just start nuts
onto ends of rod
4TH OR 5TH
_'_" SELF-TH R E ADIN G NUT HOLE
. \
FENCE GUIDE
BAR ROD
2ND HOLE
12