Procedure 26 Cross-Connecting Dsls At The Cross-Connect Terminal - Nortel 1000 Installation And Commissioning Manual

3
4
5
6
7
8
Cross-connecting DSLs Each SILC provides eight four-wire, full-duplex
ports. These ports connect to the trunk wiring facilities (typically cabling
or wiring from outside the building) to form DSLs. Since the DSLs are
polarity-sensitive, maintain signal polarity along each loop as shown
in Figure 30 "Cross-connecting an SILC port" (page 84)
"Cross-connecting an SILC port" (page
Each UILC provides eight two-wire full-duplex ports. These ports
connect to twisted pair trunk wiring facilities to form DSLs, as shown in
Figure 31 "Cross-connecting a UILC port" (page
polarity-sensitive and it is not necessary to maintain signal polarity along
each loop.
Procedure 26
Cross-connecting DSLs at the cross-connect terminal
Step
To cross-connect SILC and/or UILC ports to the trunk wiring facilities:
1
2
Copyright © 2003-2007, Nortel Networks
.
connectors in the second expansion cabinet" (page 69)
"Cable connectors in the second expansion cabinet" (page
Tag both ends of each cable with the cabinet or MG 1000S and
connector numbers.
Route cables down through the opening at the bottom of the cabinet
or MG 1000S.
Plug in the cables to the connector.
Replace the retaining bar after you have connected all cables to
the cabinet or MG 1000S.
Terminate the 25-pair cables at the cross-connect terminal.
Label the cross-connect terminal for each connector.
Figure 24 "SILC port designation label at the cross-connect
terminal" (page 69)
at the cross-connect terminal" (page 70)
designation label at the cross-connect terminal" (page 70)
label used with the BIX cross-connecting system.
Action
Identify the card type (SILC or UILC) at the cross-connect terminal.
Identify transmit and receive pins on the top of the labeled distribution
strip for the card type you are connecting.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
and Figure 25 "UILC port designation label
—End—
84).
Installation procedures 83
on Figure 22
69).
on Figure 25 "UILC port
show the
on Figure 30
85). The DSLs are not