Installing Isdn Bri Hardware For Trunk Applications - Nortel 1000 Installation And Commissioning Manual

38 Installing ISDN BRI hardware
Figure 10
Connect the ISDN BRI network termination (NT1) to the U interface

Installing ISDN BRI hardware for trunk applications

This section explains how to install ISDN BRI hardware to support ISDN
BRI trunk applications. The system must already be installed and operating
according to the instructions in Communication Server 1000M and Meridian
1 Large System Installation and Commissioning (NN43021-310) before
performing these procedures.
For a successful installation, perform these procedures in the order listed
below:
1. Select the card slots where the ISDN BRI cards will be located.
Copyright © 2003-2007, Nortel Networks
.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007