Connecting A Maintenance Terminal; Obtaining Software; Logging In To The Succession Signaling Server - Nortel Succession 1000 Installation And Configuration Manual

Page 100 of 116

Connecting a maintenance terminal

Obtaining software

Logging in to the Succession Signaling Server

553-3001-212 Standard 1.00
Maintenance
A maintenance terminal is required for installation, configuration and
maintenance of the Succession Signaling Server.
To connect and configure a maintenance terminal for the Succession
Signaling Server, see Procedure 3 on
The Succession Signaling Server Install CD-ROM includes the Succession
Signaling Server software, as well as Internet Telephone firmware and
VGMC loadware. If the CD-ROM is not available, an image can be
downloaded from the Nortel Networks website, and a CD-ROM created from
that image.
Once you have the CD, you can install new software or upgrade software on
an existing Succession Signaling Server.
To download the CD-ROM image, use Procedure 4 on
Succession Signaling Server CD-ROM, use Procedure 5 on
The Software CD-ROM must be readable in a standard CD-ROM drive. After
you create a CD from the CD image, the CD contains several directories and
files. If you cannot create a CD, refer to the CD writer's software
documentation.
To access the Succession Signaling Server from a maintenance terminal, you
must log in to the vxWorks
shell, you can change the Succession Signaling Server port speed (see
Procedure 11 on page
line interface (CLI) commands" on
October 2003
page
TM
shell using Procedure 7 on
103) and run the commands described in "Command
page 87.
44.
page 57. To create the
page
page
57.
79. From this